7040200 7042902 7041211 & 7042210 restored carbs
 

1. 1970 Chevy LS5 Carter. body built for Rochester dated J9 automatic carb 402 and 454. $325

This is the only carb I have left. If you need additional pictures, please let me know. It was rebuilt to factory specifications for the 1970 LS5 motor. Please look up the application 7040200.

2. 1972 7042902 dated 2601 CORRECTION: it is a 902 not a 910. Chevrolet 350 California Rochester quadrajet carb. This is a 1972 California carb for a Corvette, Camaro, Chevelle or Nova. If you look at the front, part of the bracket that the idle solenoid mounts to is damaged. $295

3. 1972 7042210 dated 1532 350 auto $295 Sold to Davestrucks

4. 1971 7041211 dated 1301 350 4spd $295

He charges me $225 plus shipping to restore these carbs so you are basically getting the rebuild, core and shipping for $295.

I had additional carbs done by a guy who has over 40 years experience rebuilding carburetors and has done thousands. This carb has just been restored and is ready to install. The rebuilding extras include NEW bronze bushings installed in base. ALL rebuilt quadrajets should have this done. The bases are aluminum and the shaft bores wear and cause poor idle and vacuum leaks. All NEW primary throttle plates are installed. They are also aluminum and wear out. The secondary air valve cams are plastic. This lifts the metering rods when the secondary’s open. They wear out or break causing a lean wide open. All NEW air valve cams are used in these rebuilds. New float installed. The main well fuel plugs are MT13 sealed. Other sealers will not hold up to today’s fuels and will leak. The accelerator pump cups are fluorelastomer and are blue in color. They are the only pump cups that will withstand today’s fuel additives. The black pump cups are no good and will swell or shrink. All NEW choke pulloffs. The secondary throttle plates are DAG213 sealed for a good quadrajet idle quality. The top and body are chemically color bond 420 dichromated.

The aluminum base is restored with a two part cleaning process that brings the aluminum back to the original finish. No silver paint or wire buffing is used. The bottom of base is then machined flat to prevent any potential warpage. The screws and linkage are yellow zinc plated. No rusty parts here. Carbs are tested on their machine that uses a pressure gauge and fuel meter. This assures no leaks and a good pump stream for the accelerator. A mounting gasket and an air cleaner gasket are included. You will not be disappointed.

Fedex Ground Shipping with INSURANCE is included.

$295 shipped to Conus for the 350 SB carbs and $325 shipped conus for the LS5 carb.


7040200

I need to resize my pictures. You may search 7042902 John H. and see pictures of the work.

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

7040200
Attachment 1135321

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

Attachment 1135324

Attachment 1135325

7042902

Attachment 1135326

Attachment 1135327

Attachment 1135328

7041211

Attachment 1135329

Attachment 1135330

Attachment 1135331

7042210

Attachment 1135332

Attachment 1135333

Attachment 1135334

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

Attachment 1135335

Attachment 1135336

Attachment 1135337

Attachment 1135338

Attachment 1135339

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

7041211

Attachment 1135340

Attachment 1135341

Attachment 1135342

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

If you come across a carb for a 1970 350 with an automatic for a California application, I will buy it. These are beautiful carbs!

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

John, I'm interested in that carb for the 70 402. If I can swing it and you still have it by the end of August when I come up would like to buy it. I plan on coming up Friday the 30 of August, that's the only time I can make it. I plan on being there early in the morning. I'm still interested in those other parts I talked about earlier. Please let me know your thoughts on this. Thanks Mike.

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

wow! nice!

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

Real nice work. I would take a 72 California emissions carb but can you confirm the number on that described in #2 above? There are 6 rather than 7 digits given. I thought the third digit was a "4" for 70-75 application with the fifth digit a "5" to denote CA emissions. Thanks, Pete

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

Hey Pete, it is 7042902. Typo. You can see it on one of the pictures. Also, I am building your k20 twin. Factory orange super K20 4x4, ac, tilt, parchment, slider, door edge guards. Adding tow hooks, tool box, tach speedwarning and possible shoulder harness if Wes does not hold them hostage!

Bronze 72: Mike, we will work something out when you are up here on the 70 carb.
Posted via Mobile Device

Correction: Pete i had it in my mind it was a 910 ending CA carb. It is for CA: 1972 Corvette, Camaro, Chevelle, or Nova or specific for truck!

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

looking for one for my 72 super auto with 402 v8.. got one?

think it should be 7042210? or 7042510?
if 7042210 is correct i will take it...
dave

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

Nice John! I didn't happen to see a build thread but if/when you get one going please let me know. I've made a lot of mistakes along the way and would be glad to share any details that would help with your build. Those shoulder belts may be the ones Wes pulled from a Blazer - tempting for sure!

Good to know about the "9" referencing CA Q-jets as the few decoding sources I know of make mention only of a "5" for CA emissions carbs. I'm keeping an eye out for a CA carb for my 72 Blazer - which has all the CA emissions equipment in place but the carb code isn't correct (it's more of a want rather than a need right now). What concerns me with this carb is the mounting tab for the idle stop solenoid - my Blazer has A/C and I wouldn't want a loosely mounted idle stop solenoid.

Thanks! Pete

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

I'll take it. 7042210 (72 350 auto)

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

If you got a Q-jet for a 1972 K-10 with a 350 I'd be interested.

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

yote1234 what you need is a 7042218 4bbl 72 402 10 auto

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

RPIcka if yours is auto get in line 7042210 if manual 7042211

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

7042210 sold to Deavestrucks pending payment.
Posted via Mobile Device

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

If you got another one for an auto let me know

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

The 902 is a 72 automatic carb with one additional port that can be capped. The 211 will work for an automatic if numbers are not an issue.

These are pretty good values.
Posted via Mobile Device

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

What I'm looking for is a q-jet with electric choke that I can bolt on. Something that has been rebuilt like what you have listed sounds great.

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

7042210 is sold to Davestrucks.

7042902 and 7042211 are still available.
Posted via Mobile Device

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

thanx davestrucks. very much.

Hey John.H put me in line for the next "7042218 IU" when and if you get one. thx,dave

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

man I need a carb for a 71 c-20 402 with air conditioning and an auto if you have one restored or not let me know thanks

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

I only have the 7042902 and the 7041211. I just have the core for my project.

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

Weekend bump
Posted via Mobile Device

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

John I was thinking about this and then remembered that the bracket of the idle stop solenoid is also attached by a bolt. So, do you have a bracket/screw you can use to test for stability on the 7042902 CA emissions carb (if you still have it)? I'd strongly consider it if the bracket is tight and not wobbly. Also, any interest in a partial trade for a Q-jet correct for a 1968 327 motor with an auto trans or a 1971 Q-jet correct for a 4 spd? Both of these Q-jets are non-CA emissions. Thanks, Pete

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

I don't think I have a solenoid. I can send it to you and if it does not work, you pay shipping back? You can test the solenoid bracket and decide. If you like it, you can pay me if you like it. If not, just pay shipping back and I will pay your way.

Pm your address,email and cell number and I will get it out on Monday.

We can use my account for discounted shipping too.
Posted via Mobile Device

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

John,

Do you have any parts for a 7042210 carb? I am looking for some of the linkage rods for the choke pull off and choke.

Thank you,

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

Try Bob Stone at classiccarb@aol.com

He restored my carbs and is a great person.
Posted via Mobile Device

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

Dave, just checking in. FedEx delivered on the 31st.
Posted via Mobile Device

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

It's here and looks really nice. Thanks

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

Thanks John - PM sent...

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

Thank you John

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

Pete,

Carb went out today FedEx ground. I am getting ready to send my frame out to be powder coated so the build will be started! TRL 350 motor being rebuilt and we have the trans and transfer case done.
Posted via Mobile Device

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

Nice! I'll let you know when the carb shows up - FedEx typically swings bywhile I'm at work so I often redirect packages that need a signature on delivery to a nearby pickup center. If you get a build thread going let me know. Also, I didn't realize this until late but phosphate coating brackets, hood hinges, bolts, etc. (like GM did) is a cost effective way to go and more durable than paint. Let me know if you end up in need of any parts. Best, Pete

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

Got the carb today John - Will open up the box and try the bracket tomorrow or Saturday and send a PM. Thanks, Pete

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

John looks like the bracket bolts on tight. PM sent. Pete

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

7041211 still available. This is a 71 4spd carb but will work for auto or 4spd.

$295 shipped.

Interesting trades?

Need nice parchment door panels, black high hump carpet, tach dash.
Posted via Mobile Device

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

just got one done from this guy! and highly recomend! beautiful job. thx john!

Re: 7040200 7042902 7041211 & 7042210 restored carbs
 

Hello I am wtb an original big block 1970 w/ ac and automatic quadrajet. Core or restored.I think it is 7040206 with big block linkage is that correct for my year and application. Let me know what you have or at least confirm or supply correct model etc. Thanks
.