uneven rear springs ?
 

I have new 4" drop springs in my 67 SWB, one side of the bed is 3/4" higher than the other. I would like the higher side to match the other. How can I fix this ? I was thinking about clamping a couple of coils together to lower it. Anybody done this? I have seen spacers for raising them but have never seen clamps for doing this. Thanks for the help

like a small ubolt with a bar across and nutz to tighten it down? thats what i have pictured

Thats what I'm thinking also, has to be the springs making it uneven, nothing else there.

Be sure to check the frame Height, I had the same problem, and it turned out to be the crossmembers of the box were our of whack, I ended up changing those to correct the Droop in the one side.

Good luck.

I'll do that, How was your crossmember out of whack ?