Here's what I've been doing
 

Since my tour in Korea and moving to another base here in the states-I've only come along so far. Check it out.

http://community.webshots.com/user/inthuwind

End of build...
 

Hopefully it will look like my photoshop!!

Looks like you're off to a good start, and have a good helper too :cool:

Ttt

I would stick to that plan :cool:

Really getting into it. Can't wait to see how she goes back together for you.

Sweet motor you have for her already. Progress looks good. Stay motivated.

look what came in late today!!!
 

Got new dropped center section for trailing arms--if anyone gets one of these, be ready to redrill the holes out. It is a great product, but doesn't line up to holes on the frame that well.

What product is that? ECE?

i was thinking I may get one, but I've also been looking at drilling holes and welding in 3" pipe.

Yes, it's ECE. Holes were just a tad off. No biggie though--seems to be pretty solid.

Did you call ECE about it and asked them whats up?

Not yet-it was minor, and only took me a couple minutes to use my stepping bit to drill out. I'm sure they have had others use this product. I might call them tonight.

What has been done to the 396? Looks like a great project!

396 bored 30 over,port and polished heads,forged pistons,Extreme Energy Comp Cam(286),Comp Cam 1.71 roller rockers, Edelbock RPM Air Gap intake(polished)oval port~~

396 came out of the '69 Camaro-375hp--now-should be close to 500hp

Your gonna have a blast driving it!

I was almost tempted to throw some 4wheel drive axles under it--