A-arms for c20
 

Hi im in the process of converting my c20 8 lug to a 5 lug. I've got new spindles from ECE new rotors upper and lower ball joints inner and outer tie rods calipers and hoses. Once i started putting it all together i noticed the shafts that run through my upper a-arms is completly stripped out not only is the shaft stripped but the threads are gone out of the a-arms. So my ? is where can i get a tubular set of a-arms for my C-20

Re: A-arms for c20
 

Take a look at Classic Performance Products. I just got my tubular A-arms from them, as well as the tubular motor mounts for my LS-1; all for my 68 Chevy truck. I haven't installed yet, but they look dang good on the floor. http://www.classicperform.com/

Re: A-arms for c20
 

Will the a-arms for the c10s work on my truck ?

Re: A-arms for c20
 

3/4 ton upper A arms are not the same as 1/2tons. Just go get some used ones off of a 73-87 3/4ton gm truck. They are the same as 67-72 3/4ton arms, that is if you dont find or decide not to go tubular. Good luck.

Re: A-arms for c20
 

Are the lower arms the same on the 73-87 3/4 ton trucks also? Is that a direct bolt on for them? I am thinking of upgrading my 69 Chevy to disc brakes and would like to just change the spindle if the 73 and up trucks will interchange with my 69 a arms. Thanks

Re: A-arms for c20
 

Ne one no where u can get tubular a arms for a 3/4 ton c20