The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)
-   -   fast grille removals for secret location (https://67-72chevytrucks.com/vboard/showthread.php?t=239442)

Luvlegs 05-03-2007 01:13 PM

fast grille removals for secret location
 
I searched around and couldn't find anything detailed enough...

HOPEFULLY Going this weekend to pick up a few grilles - I have to pull them though and have a limited amount of time. Perhaps someone will have an answer or two.

I am pulling a 71 outter/inner - there are rivets on it and bolts.... not sure where they are all at or what tools I might need.

I am also going to pull a 67 and 2 68-69s (one GM) - I started 2 of them but had to give up as I ran out of time and couldn't find all the danged connection points.

I have to walk quite a ways and fight through a jungle to get to them so I can't really carry or haul all my tools, a compressor, etc. I did manage to drill out and take home a sway bar and all the brackets... so I know it can be done (the grilles) but it was a pain. I just have to avoid pulling bumpers and fenders as it eats up time.

If anyone can tell me size, location, chisel, etc, I would appreciate it greatly.
(not just the grilles either but if there are any tricks to say, headlight buckets, fender parts of the grilles, etc)


I'm kinda in a race for time as I am swampped at work and home/momma/baby girl etc and don't have any experience with anything other than my 72 (and that's why I need one of the grilles! hahaha)
And I'm afraid my secret location will be discovered.....

powell72 05-03-2007 09:46 PM

Re: fast grille removals for secret location
 
On 69-72's, drop the bumper, remove headlight bezels, unbolt the four (if I remember correctly) bolts attached to the latch and center support, remove the eight bolts that hold the outer grille brackets to the fenders and pull straight out. It will sneak out past the headlights. Don't mess with the rivots just leave the brackets on the grille. A wobble socket and long extension work good for getting those bolts, I believe they're 1/2''.

Luvlegs 05-03-2007 10:10 PM

Re: fast grille removals for secret location
 
MUCH appreciated! I was over thinking it and didn't even consider leaving the brackets attached... Now as for the 67s and 68s... and is there a center bolt at the bottom of the 68 gm grille? (I think it was a 68 - it had two marker lights at the bottom just above the bumper - seperate chrome on each fender and another thinner chrome strip across the top).... Again, any info is much appreciated and as you can tell by the time, my day has just finished up...

powell72 05-03-2007 11:28 PM

Re: fast grille removals for secret location
 
Maybe somebody else will chime in on the 67/68's. I haven't had one of those for about eight years, I'm a little rusty on those.

AR15DEFENSE 05-03-2007 11:47 PM

Re: fast grille removals for secret location
 
be careful, last time I visited my "secret location" I was 16 and got arrested.

cstm68 05-03-2007 11:53 PM

Re: fast grille removals for secret location
 
the 67-68s (two bolts on top and two bolts on bottom on bolth sides)=8
then i think theres 4 in the latch( 1 bottom 1 center and 2 on top) then 4 screws in each headlight bezzel.
then two nuts on each turn light or just dissconect the wires and pull thoes with the grille

RicksTrucks 05-04-2007 01:35 AM

Re: fast grille removals for secret location
 
On the 67-68, if you want to take the gravel pan too, they can be a bear since they are probably at the lowest point and get very rusty. The last one I pulled, I had the guy lift the truck up so that I could get to them. Another one was on two flat front tires, so I couldn't get to the bolts. When I came back later with a jack, the truck had been crushed.

cstm68 05-04-2007 01:48 AM

Re: fast grille removals for secret location
 
Quote:

Originally Posted by RicksTrucks (Post 2157607)
On the 67-68, if you want to take the gravel pan too, they can be a bear since they are probably at the lowest point and get very rusty. The last one I pulled, I had the guy lift the truck up so that I could get to them. Another one was on two flat front tires, so I couldn't get to the bolts. When I came back later with a jack, the truck had been crushed.

oops forgot about that

Luvlegs 05-04-2007 08:41 AM

Re: fast grille removals for secret location
 
hmmmm like I said, I have to walk quite a ways to get to 'em..... and the 67s are flat on the ground (up to the frame)..... Thanks for the input guys... hopefully, this time tomorrow I am up to my elbows in 'em and I WILL be taking some pics....


All times are GMT -4. The time now is 08:24 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com