The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1967 - 1972 Chevy/GMC Suburbans & Panels Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=38)
-   -   Alluminum Driveshaft Question (https://67-72chevytrucks.com/vboard/showthread.php?t=243220)

valentini 05-30-2007 10:39 AM

Alluminum Driveshaft Question
 
Hello everyone,

I have recently built a 1972 GMC pickup and lowered it with Air Ride Suspension. My current issue revolves around the driveshaft length. It measures 73.5" and needs to be constructed of aluminum. Can anyone give me information regarding you experience with this type of setup? Also I am trying to locate a reputable shop in Colorado that can build this for me cost effectively. Any help is appreciated.

Thank you,

boostat4500 05-30-2007 03:47 PM

Re: Alluminum Driveshaft Question
 
The driveshaft in my truck is the factory one out of an 01' Chevy 3/4 ton. Pretty sure it's aluminum. Just had to have the length adjusted. Would probably be easier and cheaper to go this route rather than getting a custom one made.

71chevylowrider 05-30-2007 04:03 PM

Re: Alluminum Driveshaft Question
 
Too bad your not closer, my buddy works at a place that makes drivelines, I'm gonna have them shorten mine when I get a 700R4


All times are GMT -4. The time now is 07:30 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com