The 1947 - Present Chevrolet & GMC Truck Message Board Network

I have a few items for sale and will post pictures a little later as some of them are in storage. Please respond in thread if interested -NO PMs Please-

1) Pair of Blue Hubs and chrome retainers- these are used and faded, chrome is not very good but will do for daily driver,the knobs are unbroken and worked perfectly before tear down; sorry no hardware- $40 and shipping

2)AM Radio- this is a working radio, case is very clean and has a NOS faceplate on it, also included are CST knobs (very clean) and the retainer cups for the dash- $80 and shipping

3)Th400 kick down switch- this is a 67-70 kick down switch with all pieces including the tab that mounts to the carb to actuate the switch and wiring harness; to my knowledge these are not being reproduced and are hard to find complete- $65 and shipping

4)Big block heat shield- this is a piece often over looked when converting a sb truck to bb, a must if you want it to be original this is the shield that mounts to the firewall/floor not the one on the manifold -$25 and shipping
5) Set of 4 Blue bowtie 69-72 1/2 ton 2wd dog dish hubcaps. These are in very good condition minimal scratches and dings- 7.5/8 on scale of 10. Pleae note that two of these look to have had the bowtie painted at some point but still look good. $100 and shipping

6) Pair of 72 Custom Deluxe/ Cheyenne/Super door panel stainless trim rings- these are in good condition, but could use a good polishing, retaining nails are intact. $50 and shipping

7)71-72 trute truck tilt- got this in trade on some work, it looks rough and is missing the indicator cover but column is not sloppy in any of the tilt positions. $200 and shipping

Items I am willing to consider in trade: Black beach seat cover w/cheyenne scroll, front and rear windshield moldings-repop ok but needs to be ding free/scratch free, cowl vent flap for A/C this is the piece located in the cowl actuated by vaccum canister on firewall.
If prices are out of line make me an offer, I have a few pieces left to buy for the 4x4 and hopefully I can start putting it together;)