WTB Looking for a Tin for a tach guage cluster.
 

Hey guys, I'm looking for a Black tin for a tach cluster. I got a cluster, but some one cut up the tin inside to install a guage in the bottom whole.

Thanks....

Re: WTB Looking for a Tin for a tach guage cluster.
 

Anyone??

Re: WTB Looking for a Tin for a tach guage cluster.
 

I might have something for you PM me

Re: WTB Looking for a Tin for a tach guage cluster.
 

I might buy your old one if it's useable just with the extra hole cutout...thinking of adding a clock or air pressure gauge....

Re: WTB Looking for a Tin for a tach guage cluster.
 

70shortfleet, pm sent....

VA72C10, Here is the on that I have.....

http://i295.photobucket.com/albums/m.../Photo0578.jpg

http://i295.photobucket.com/albums/m.../Photo0580.jpg

The Temperature gauge whole has been cut out....Let me know what you think.

Re: WTB Looking for a Tin for a tach guage cluster.
 

Here is one with a clock hole that I did

Re: WTB Looking for a Tin for a tach guage cluster.
 

How did you cut out that clock hole with the factory rolled lip look. ???



PT

Re: WTB Looking for a Tin for a tach guage cluster.
 

I have a punch press:chevy:

Re: WTB Looking for a Tin for a tach guage cluster.
 

I have made the tach holes before with the lip by marking the hole, cutting it out, dremeling the edges, and using a non-scarring mallet over a large pipe. I was going to do the exact same idea as 70shortfleet for a converted clock I have. Trevor

Re: WTB Looking for a Tin for a tach guage cluster.
 

If you cannot find a used one, I know GMC Pauls sells the inner and outer tin in a set for $44.95.
http://www.mcssl.com/SecureCart/View...4f387a7&bhcp=1




PT :chevy:

Re: WTB Looking for a Tin for a tach guage cluster.
 

Ok this is what I done... I had a extra tin layin around that wasnt being used. I cut the the bottom off of it that I needs and fixed the tach tin.

http://i295.photobucket.com/albums/m.../Photo0581.jpg