ignition switch replacement
 

ok so does anyone know how to replace the ignition switch on a 68 c10, ordered the new one but cant seem to figure out how to remove the old switch. any help would be appreciated. i will post some pictures in a little while. thanks again

Re: ignition switch replacement
 

put a paper clip in the little hole on the switch, turn it-can't remember which way- and the tumbler will come out.

Re: ignition switch replacement
 

You have to remove the lock cyl. first. Turn switch to acc. position and insert wire into hole on face of lock and push in. You will feel a spring loaded pin as you push. Then turn cyl to the left and pull. You might have to wiggle it a bit , but it should pull out.