The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)

- The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)

- - trim (https://67-72chevytrucks.com/vboard/showthread.php?t=564875)

71badblue

02-06-2013 09:07 PM

trim

i have a 71 and it has no holes for the clips for upper and lower moulding. anyone know to go about putting it on without the clip holes?

too much stuff

02-06-2013 09:15 PM

Re: trim

71-72 had the stick on clips and a screw or clip with nut on some of the ends.

71badblue

02-07-2013 12:15 AM

Re: trim

how far apart and where

Scott>72-GMC

02-07-2013 12:18 AM

Re: trim

1 Attachment(s)

Posted via Mobile Device
Posted via Mobile Device
I had a post similar to this not to long ago. The only holes my bed has is at the end u might see in this pic
Posted via Mobile Device

71badblue

02-07-2013 05:35 PM

Re: trim

scott i take it ya never got an answer really either

Scott>72-GMC

02-07-2013 06:00 PM

Re: trim

Well from what I take there is one clip in the rear and the rest is held down with adhesive clips That's the bed I'm not to sure about the doors or fenders
Posted via Mobile Device

terry b

02-07-2013 06:04 PM

Re: trim

ttt

Scott>72-GMC

02-07-2013 06:14 PM

Re: trim

1 Attachment(s)

Posted via Mobile Device
The catalog offers this
Posted via Mobile Device

JointTech

02-07-2013 09:11 PM

Re: trim

PO had sheetrock screws holding mine on in a few spots. Then had some spring loaded clips that I think were pop rivetted in. I had to grind the clips off. truck was repainted so that may have been done then. Sheetrock screws probably came later...

Scott>72-GMC

02-07-2013 09:14 PM

Re: trim

Sheetrock screws. Lol. There's one way to go
Posted via Mobile Device

All times are GMT -4. The time now is 08:24 PM.