![]() |
Flaming River column install questions
Hey all,
I am in the process of installing a FR #20007 tilt column. The stock column has a slot in the top of the column to fit the "nub" in the arch of the underdash column support. I have heard of people recutting this slot when relocating a stock column. I am very leary of trying to cut this slot in my new column as I know the signal wiring runs on the top side of this column. So what have you guys done? Grind the "nub" off? If so, are the 2 clamps sufficient without? Unrelated to this, are the contacts in the arched (original) signal connector the same as in the flat (later) connector? Want to know if I can just pull the terminals to swap the connector bodies? Thanks in advance, Shane |
All times are GMT -4. The time now is 01:08 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com