Help with my 2004r 200r4
 

<UIMenuController: 0x1fc39b60><UIMenuController: 0x1fc39b60><UIMenuController: 0x1fc39b60>I'm doing my 2004r tranny swap and I ran into a situation. I'm not a transmission guy but I'm mechanical enough to rebuild an engine. how do I put the linkage back in the transition? where do I get the parts? I hope this picture loads to help

Re: Help with my 2004r 200r4
 

Here is the picture.
Posted via Mobile Device

Re: Help with my 2004r 200r4
 

where did it go? Did it fall into the pan? Have you had that pan of?

Go to www.wittrans.com they have a good blow out parts diagram for that trans.

Re: Help with my 2004r 200r4
 

Looks like trans is not assembled correctly. Using blkcorvair's recommended site, www.wittrans.com , see the places and parts #'s and approx. where they fit into and onto the trans.
HTH,
sam

it's broken off inside. it came out of a running impala that was wrecked. I just put it in my truck today. I'm guessing that when he removed the trans he didn't put a lock wrench on the shift shaft. I've never replaced one on a 200-4r. I've help with one on a th350. is it the same procedure?