The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)
-   -   What size are deez nuts (https://67-72chevytrucks.com/vboard/showthread.php?t=661308)

hdff 02-23-2015 09:34 PM

What size are deez nuts
 
I need to take the nuts on the ubolts on the rear end off to install an ece super track bar. I tried a 1" & a 1 1/8 and neither fit so I need to go shopping tomorrow, I assume it will be a 1 1/16 but would like to know for sure. Anyone know right off the top of their head?

EARNHARDT#3 02-23-2015 10:35 PM

Re: What size are deez nuts
 
Tape measure or dial caliper....busting doze nutz LMAO

Kimjongthrill 02-23-2015 11:03 PM

Re: What size are deez nuts
 
Well if 1 inch is too small and 1-1/8 is too large then 1-1/16 will be the fit. did mine a long time ago can't remember off the top of my head

Wizo 02-23-2015 11:12 PM

Re: What size are deez nuts
 
18" crescent wrench and a cheater bar to:metal: take them off and then a 3/4" torque wrench that will go to 150 foot pounds to torque them back up.

Kimjongthrill 02-23-2015 11:18 PM

Re: What size are deez nuts
 
3/4 torque wrench to 150!!!! 1/2 at 235 is more like it. 3/4 should be 250 to 600

Lanman1972 02-24-2015 07:39 AM

Re: What size are deez nuts
 
I have a broken 1 1/16" x 1/2" drive Socket you can have! I had to use a 3/4" drive and a long cheater. Them things are tough!

Steve Cole 02-24-2015 12:47 PM

Re: What size are deez nuts
 
1 1/16" is correct. I know because I had to go buy the socket.

michael bustamante 02-24-2015 12:59 PM

Re: What size are deez nuts
 
1 1/16

hdff 02-24-2015 07:04 PM

Re: What size are deez nuts
 
yep that is correct, went and bought a impact socket today. will start the job after I get home from the dentist tomorrow morning. hope that I am not getting into something over my head. after the install I will have to go get my exhaust modified cause the new track bar appears that is is going to hit it...:(


All times are GMT -4. The time now is 06:21 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com