Question for 67-72 stepside guys
 

my new bed and fenders have a hole for a rear brace . my question is do any of your trucks have a brace here ? If so does anybody know where I get one. According to lmc and other 67-72 truck parts retailers it doesnt have one. I saw one in the assembly manual as well. The pic is a 66 model ( top left brace in pic )and I know they had it but like I said my new bed and step fenders have the wholes to bolt it on.

Re: Question for 67-72 stepside guys
 

Mine has the braces but I don't know where to buy them. Find someone parting one out here on the board.

Re: Question for 67-72 stepside guys
 

I got mine from AMD http://www.autometaldirect.com/tripl...up-p-4883.html

Re: Question for 67-72 stepside guys
 

cool thanks

Re: Question for 67-72 stepside guys
 

Even better for me, they are in Buford GA, literally 4 miles from my house....no shipping. I got my bedsides from them too.

Re: Question for 67-72 stepside guys
 

LMC: Part number 7? 38-7368

Re: Question for 67-72 stepside guys
 

no number 7 is the center braces and longer

Re: Question for 67-72 stepside guys
 

i ordered them but they are wrong that number was the center braces as well, I'm looking for the ones in the pic and the same location thanks for your help

Re: Question for 67-72 stepside guys
 

Is that one shorter that the one's you ordered? I have a short one I took off my '67 and used 4 long ones. This one is 13 1/4" long bent on one end and straight on the other. I will send it to you for $10 including shipping if you think it will work.

Re: Question for 67-72 stepside guys
 

If you have a welder you can make your own...5/16" or 3/8" round bar and some scrap 1/8' flat stock....measure how long you need them to be....drill a few holes. Easy fab job.

Re: Question for 67-72 stepside guys
 

I misread your question. I do have all the OE fender braces on my 69 step side. I'd be glad to snap a pic or two if it will help you.

Re: Question for 67-72 stepside guys
 

Pretty sure I have a complete set from my ‘67 long step if you’re interested

Re: Question for 67-72 stepside guys
 

I do have a shorter one for the rear on my '72 - depending on the bend at one end it's 12.5 - 13". Just like the longer ones (round bar, flat ends) but shorter and slightly different bend at one end.
Boog - I'd like to see that photo - can't locate the photo I took of the supports still on my fenders of my '72.
Don't forget the triangulated brace that goes from under the side marker light pocket, down and back. Here are photo's:

Re: Question for 67-72 stepside guys
 

I kick myself as I had two complete sets of braces for stepside fenders and I let one set go with a set of rear fenders I sold a few months ago. I kept a complete set for my truck but let the other set go with those fenders.

Re: Question for 67-72 stepside guys
 

Here's my thread on the fender braces.

There are four per side, and only the two long ones are reproduced for some reason.

http://67-72chevytrucks.com/vboard/s...d.php?t=731737