69 longhorn<<<<
 

wanted to make sure you saw this so decided to make a new topic, you wouldnt happen to have any of those little pivot balls leaft from when you used to run a straight would you?
Thanks
J.B.

At one time ,I had a lot of spare Hardware like that,But havent done as much parting out in the last few yrs. I did hang onto 1 complete stick setup for the longhorn, for"someday"......still think about a 6spd Richmond from time to time! You shouldnt have too much trouble finding a screw in ball,the 73 up trucks had them, & also a lot of the older cars did. The thread size is the same(1/2" 13 NC). Good luck.....69 longhorn.