The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**VetteVet** · 02-24-2005, 08:54 PM

here's a novel idea. Go to the junkyard and find one on an older car or truck and cut about six inches of wire off with it and then splice it into the wire on your vehicle. Then drink three beers and the fingers won't hurt so bad.
Remember, it goes on the end of the sender at a 90 degree angle not straight on.
Most horns have a spade connector on the wire with the plastic cover. Not the same but it should work,
Vettevet--old and scarred

02-24-2005, 08:54 PM	#25
VetteVet Msgt USAF Ret Join Date: Jan 2005 Location: Kalamazoo, Michigan Posts: 8,723	here's a novel idea. Go to the junkyard and find one on an older car or truck and cut about six inches of wire off with it and then splice it into the wire on your vehicle. Then drink three beers and the fingers won't hurt so bad. Remember, it goes on the end of the sender at a 90 degree angle not straight on. Most horns have a spade connector on the wire with the plastic cover. Not the same but it should work, Vettevet--old and scarred __________________ VetteVet metallic green 67 stepside 74 corvette convertible 1965 Harley sportster 1995 Harley wide glide Growing old is hell, but it beats the alternative.