[bagged91]

Thanks guys...

I bought 3 new rockers(1 drivers, 2 pass). I had to cut up both pass rockers as the front pass rocker is diff on a burb than a p/u and obviously the 3rd door rocker is shorter. Drivers side went in fine. I bought a nice drivers side LWB bedside and cut it up for the wheel arch & lower panels. I used the inside of the bed for new inner rockers. The pass side I cut up a pass side SWB bedside for the dogleg and used a upper wheel arch panel for the arch(these both came with the truck). I also had to put in a patch on each side below the side markers and also one by the drivers doorjamb. Still need to block it out and have to finish the wheeltubs too.