The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

shelby987 · 11-10-2005, 04:56 PM

I was wondering about a brownie setup too....these are the units built by watson/dana/spicer/brown lupe right? (I have been unable to find ANY information on any of these units.....does anyone know anything about them?).

VTblazer, AWESOME job.....I couldn't figure out why the driveshaft was SOO short until I looked at additional pics, I just figured it would bolt to the output side of the transfer case like the gear venders....I like this way better....tucks that drive shaft up there nicely too...what angle did you end up with on the driveshaft when you were done?

11-10-2005, 04:56 PM	#8
shelby987 Registered User Join Date: Mar 2005 Location: Just outside Durham, NC Posts: 894	Re: 2spd Over Drive Install w/Pics I was wondering about a brownie setup too....these are the units built by watson/dana/spicer/brown lupe right? (I have been unable to find ANY information on any of these units.....does anyone know anything about them?). VTblazer, AWESOME job.....I couldn't figure out why the driveshaft was SOO short until I looked at additional pics, I just figured it would bolt to the output side of the transfer case like the gear venders....I like this way better....tucks that drive shaft up there nicely too...what angle did you end up with on the driveshaft when you were done?