The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

hcgviper · 01-19-2006, 11:05 PM

I have reviewed some posts on driveshafts but curious about something, can someone give some advise pertaining to 1 peice versus 2 peice? I am thinking about converting to a single drive shaft on my truck when I rebuild it. Is this going to be a lot of work in regards of machining to make one fit and function correctly? I plan to beef up the frame, and drop a nice muscle motor to back the 4.58 gears.

One other question in 68 did they have limited slip or am I correct to assume this is a posi track [3/4 ton rear]

Any advise will be appriciated, this is my first project from the ground up.

01-19-2006, 11:05 PM	#1
hcgviper Registered User Join Date: Jan 2006 Location: Hutto Posts: 4	68 Chevy 20 Project I have reviewed some posts on driveshafts but curious about something, can someone give some advise pertaining to 1 peice versus 2 peice? I am thinking about converting to a single drive shaft on my truck when I rebuild it. Is this going to be a lot of work in regards of machining to make one fit and function correctly? I plan to beef up the frame, and drop a nice muscle motor to back the 4.58 gears. One other question in 68 did they have limited slip or am I correct to assume this is a posi track [3/4 ton rear] Any advise will be appriciated, this is my first project from the ground up. Last edited by hcgviper; 01-19-2006 at 11:05 PM.