View Single Post
Old 01-21-2006, 08:10 PM   #2
PanelDeland
I am a Referee of life.
 
PanelDeland's Avatar
 
Join Date: Jun 2000
Location: Greensboro N.C.
Posts: 13,992
Re: column to floor shift (pics?)

Hey TX cowboy, you will have a hard time using someone else's mesurements.There are some differences in tranny position,though they will be minor.The other differences will be in floor shifters.They may mount a little different or be closer further from the floor or other variables that make a difference.The best way I have found to do this is to mount the shifter without the shifter arm and then put it thru the gears marking the throw or distance the shifter lever moves in each gear.By doing so you can cut the smallest workable hole in your floorboard.Each brand of shifter will come with installation procedures that should be followed.It may also come with a template for the hole in the floor.
__________________
The 47-present Chevrolet and GMC Truck Message Board Network,it's owners,moderators,members,and associates of any type should not be held responsible for my opinion.
You can't fix stupid,not even with duct tape.
"My appearance is due to the fact that "GOD" does punish you for having too much fun!"
Barrett-Jackson has perfected alchemy,they make rust into gold!
"You can lead a horse to water but you can't saddle a duck"
"Cleverly disguised as a 'Responsible Adult'
"Sometimes your Knight in shining armor is just a retard in tinfoil"
PanelDeland is offline   Reply With Quote