View Single Post
Old 07-21-2006, 11:43 PM   #4
badpeanut
Not a bad nut after all..
 
badpeanut's Avatar
 
Join Date: Dec 2000
Location: ND
Posts: 1,760
Re: 2 piece driveshaft timing question

I always thought the U-joints on the front half and back half should be exactly 90° from one another, but I remember the factory service manual describing an installation procedure based on counting the splines between the two shafts that is slightly different than 90°. My manual isn't accessable right now, but I can check later if needed.
__________________
'05 Chevy 2500HD 4x4
'72 GMC LWB 4x2 driver
'72 Chevy LWB 4x4 plow truck
'71 Blazer 4x4 driver
'70 GMC LWB trailer
badpeanut is offline   Reply With Quote