The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Best way to shrink metal when there is no acces to the rear of the panel?

bagged74 · 08-26-2006, 09:28 PM

you can probably get a shrinking tip for you stud welder. just heat it and immediately cool it with water or compressed air.

08-26-2006, 09:28 PM	#4
bagged74 its just $$$$$ Join Date: Jul 2003 Location: OK Posts: 2,078	Re: Best way to shink metal when there is no acces to the rear of the panel? you can probably get a shrinking tip for you stud welder. just heat it and immediately cool it with water or compressed air.