The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**kwmech** · 08-29-2006, 08:31 PM

You remove the rear yoke and seal housing, they give you a clamp that holds the rear bearing in place. Then the adaptor bolts on. The unit follows the centerline of the shaft. The wiring harness (hooked up correctly) will not allow O.D. engagement in 4wd. Just make sure that you shim the small sleeve correctly. All the instructions are in the package. Not all that hard.

08-29-2006, 08:31 PM	#5
kwmech Senior Member Join Date: Mar 2003 Location: Colfax-California Posts: 8,717	Re: Gear Vendors Overdrive install You remove the rear yoke and seal housing, they give you a clamp that holds the rear bearing in place. Then the adaptor bolts on. The unit follows the centerline of the shaft. The wiring harness (hooked up correctly) will not allow O.D. engagement in 4wd. Just make sure that you shim the small sleeve correctly. All the instructions are in the package. Not all that hard.