The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

72CREWCAB · 09-09-2006, 01:10 AM

Don't know if you got an answer to this but when I swapped mine over to 1 ton I used the following.
Use your stock a-arms from the 3/4 ton. The bottom ball joint is the same for 3/4 ton and 1 ton 65-87. Change the upper to the 73 and up ball joint and 73-87 1 ton spindles will bolt up. Use 73-87 3/4 ton inner and outer tie rods and sleeves with the stock 72 3/4 ton center link and idler/pitman arms and you should be in business. If ya already got it done this is redundant! Hope this helps.

09-09-2006, 01:10 AM	#6
72CREWCAB Registered User Join Date: May 2002 Location: homer ak Posts: 149	Re: Dually Don't know if you got an answer to this but when I swapped mine over to 1 ton I used the following. Use your stock a-arms from the 3/4 ton. The bottom ball joint is the same for 3/4 ton and 1 ton 65-87. Change the upper to the 73 and up ball joint and 73-87 1 ton spindles will bolt up. Use 73-87 3/4 ton inner and outer tie rods and sleeves with the stock 72 3/4 ton center link and idler/pitman arms and you should be in business. If ya already got it done this is redundant! Hope this helps.