The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Switched from 68 to 72 spindles, and camber is way off...

Jim_PA · 09-12-2006, 11:16 PM

Did I do something wrong? when looking straight at the front of the truck, the front tires look like this:

\ ...... / ---- (positive camber)

Ok, that's pretty exaggerated, but it's very obvious when just looking at it.

Any ideas or something I might have missed? I used 72 spindles and upper/lower ball joints when I did this conversion.

09-12-2006, 11:16 PM	#1
Jim_PA Registered User Join Date: May 2005 Location: PA Posts: 2,696	Switched from 68 to 72 spindles, and camber is way off... Did I do something wrong? when looking straight at the front of the truck, the front tires look like this: \ ...... / ---- (positive camber) Ok, that's pretty exaggerated, but it's very obvious when just looking at it. Any ideas or something I might have missed? I used 72 spindles and upper/lower ball joints when I did this conversion. Last edited by Jim_PA; 09-13-2006 at 10:12 AM.