The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

b.sharp · 03-20-2007, 02:00 PM

Special-k,

That is exactly what happened. My striaght axle was a top mount but the straight axle had about a four inch drop from spindle to spring perch. The four wheel drive springs set in the exact same location but several inches higher. I know the difference in tire size and axle tub sizing aren't enough to get the lift I need. I wanted to have springs made for the rear. I just need a place to contact. I'm not sure there is anyone around my area that can do this. Chat with you guys later, I would post pictures if it would let me. I have no :url
I need to copy them from my computer and it doesn't want to give me that option.
B.Sharp

03-20-2007, 02:00 PM	#7
b.sharp Registered User Join Date: May 2006 Location: Frankfort, Kentucky Posts: 508	Re: Rear Spring question Special-k, That is exactly what happened. My striaght axle was a top mount but the straight axle had about a four inch drop from spindle to spring perch. The four wheel drive springs set in the exact same location but several inches higher. I know the difference in tire size and axle tub sizing aren't enough to get the lift I need. I wanted to have springs made for the rear. I just need a place to contact. I'm not sure there is anyone around my area that can do this. Chat with you guys later, I would post pictures if it would let me. I have no :url I need to copy them from my computer and it doesn't want to give me that option. B.Sharp Last edited by b.sharp; 03-20-2007 at 02:01 PM.