[Musclerodz]

Originally Posted by ChevyDude

Set the seats in the truck first to see if they would work. Seemed to be just fine. Before removing them marked the outside edge of the seat rail on the carpet with masking tape. Then set the seat on a large piece of tile setters brown Aqua Bar heavy paper and reached under the seat and marked the holes. Put the template on the edge where my masking tape was, cut out the carpet in the holes to be drilled areas. Drilled holes, made heavy steel removable plates to go under the cab on each bolt for safety and tightened them down. Used grade 8, inch and a half long ,1/2" bolts. Ran the electrics to the positive feed from the battery that is under the center console.

No seat modifications was the important part. I will start looking for a set. Thanks

Mike