The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Tips on getting the last 3/4 inch when installin motor?

Longhorn Man · 04-26-2007, 12:51 PM

put the tranny in grear, jack up the rear of the truck a bit, and turn the driveshaft a tad as you try and slide them together.
Another trtuck, is to get in the truck, and depress the clutch pedal... kinda hard with the stupid z bar set up though... you could bolt it all up and then hit the pedal I guess.

04-26-2007, 12:51 PM	#16
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,690	Re: Tips on getting the last 3/4 inch when installin motor? put the tranny in grear, jack up the rear of the truck a bit, and turn the driveshaft a tad as you try and slide them together. Another trtuck, is to get in the truck, and depress the clutch pedal... kinda hard with the stupid z bar set up though... you could bolt it all up and then hit the pedal I guess.