The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

*ksjh1316* · 10-02-2007, 11:27 PM

The 400's are hard to kill just rob some hp. If the tranny ran fine just change the seals on it as well as the fluid and you should be fine. Yes you have to change the front section of your drive shaft to have it match up but you can usually purchase one off the board for pretty cheap to get your driveshaft to the right length. Are you going to just run a floor shift with this combo or change out the column?

10-02-2007, 11:27 PM	#2
ksjh1316 Account Suspended Join Date: Jul 2007 Location: Wichita KS Posts: 1,599	Re: Engine/Trans Advice The 400's are hard to kill just rob some hp. If the tranny ran fine just change the seals on it as well as the fluid and you should be fine. Yes you have to change the front section of your drive shaft to have it match up but you can usually purchase one off the board for pretty cheap to get your driveshaft to the right length. Are you going to just run a floor shift with this combo or change out the column?