The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Frizzle Fry · 01-12-2008, 05:59 AM

I ran wires through both my A-Pillars, but the Burbs have a removable headliner instead of the metal inner roof skin making life MUCH easier.

Burbs have wires running up the driver's A-Pillar from the factory (tail/brake lights) with a gromet in the upper DS kick panel.

I don't see why it couldn't be done on a truck if you are willing to make an access point that can later be closed/covered.

The A pillars have two "passages." I found that the wires must be run in the FWD of the two passages. At least that seemed to be the case for mine.

01-12-2008, 05:59 AM	#13
Frizzle Fry Registered User Join Date: Aug 2005 Location: Hillsboro Oregon Posts: 6,449	Re: To difficult to run wire? I ran wires through both my A-Pillars, but the Burbs have a removable headliner instead of the metal inner roof skin making life MUCH easier. Burbs have wires running up the driver's A-Pillar from the factory (tail/brake lights) with a gromet in the upper DS kick panel. I don't see why it couldn't be done on a truck if you are willing to make an access point that can later be closed/covered. The A pillars have two "passages." I found that the wires must be run in the FWD of the two passages. At least that seemed to be the case for mine. Last edited by Frizzle Fry; 01-12-2008 at 06:29 AM.