The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Sport/Truck · 04-01-2008, 06:39 AM

I want to make a bracket to mount my proportioning valve to the frame.
I’m thinking all it will require is the lower lines to be cut and flared. And the uppers replaced with longer ones. Is this hard to do? Is it a double flair? Any insight on how to do this/where to put it would be helpful.
Ive seen this done here before, but nothing came up with a specific search.
And a search with just proportioning valve....well, just tons of info

Thanks
s/t

04-01-2008, 06:39 AM	#1
Sport/Truck Sierra Grande Club Join Date: Jan 2007 Location: New Mexico USA Posts: 2,433	Relocating proportioning valve I want to make a bracket to mount my proportioning valve to the frame. I’m thinking all it will require is the lower lines to be cut and flared. And the uppers replaced with longer ones. Is this hard to do? Is it a double flair? Any insight on how to do this/where to put it would be helpful. Ive seen this done here before, but nothing came up with a specific search. And a search with just proportioning valve....well, just tons of info Thanks s/t Attached Images __________________ 1971 GMC Sierra Grande, 1/2 ton short wide, original 4 bolt 010 020 block & heads. (matching #'s). 383 stroker, SMI q jet 750 cfm, Lunati Voodoo 60102 cam, Scorpion roller rockers, Spin Tech pro street mufflers with X pipe. Last edited by Sport/Truck; 04-01-2008 at 06:45 AM.