The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

stope4 · 08-15-2008, 04:40 PM

had to change my HEI module so i pulled the distributor and replaced the module and the coil at the same time. Once I got the truck started, I adjusted timing at around 8 degress based on mark on balancer. Since then the truck is very hard to start. The engine turns over real good but seems to flood and then smoke pours out of the carb without starting. I have to press the gas pedal to the floor and continue to try to start the engine. I keep the gas pedal floored and start trying to crank the engine. When I stop cranking the engine it putters to a start. I've adjusted timing numerous times all causing the engine to maybe start better but run worse. Can't seem to pinpoint problem. Any suggestions?

08-15-2008, 04:40 PM	#1
stope4 Registered User Join Date: Jan 2006 Location: Houston Posts: 434	Engine hard to start had to change my HEI module so i pulled the distributor and replaced the module and the coil at the same time. Once I got the truck started, I adjusted timing at around 8 degress based on mark on balancer. Since then the truck is very hard to start. The engine turns over real good but seems to flood and then smoke pours out of the carb without starting. I have to press the gas pedal to the floor and continue to try to start the engine. I keep the gas pedal floored and start trying to crank the engine. When I stop cranking the engine it putters to a start. I've adjusted timing numerous times all causing the engine to maybe start better but run worse. Can't seem to pinpoint problem. Any suggestions?