Quote:
Originally Posted by grendel
torch, hammer and a bit of elbow grease can fix that...
|
Seriously about the torch?? Heat on the frame won't affect the structual integrity and heat treat? Or is it common practice?
I will tackle about anything to save this truck, and I already have, but I was reluctant to heat the frame rails to get them straight.
Any frame metalurgists out there??
Any ideas accepted.
__________________
69 K-20 cloned to a 67 with front clip and some other stuff.
383 .040 over
Crane roller cam lifters and rockers ,1.6 intake ratio, Open chamber heads, 9.5-1 compression ratio, 2.02 intake valves , Edelbrock performer Air Gap manifold Carter AFB performer 750cfm, MSD ignition, SM465 NP205 4.10 gears:
