Thread: Joined the club
View Single Post
Old 11-09-2008, 12:02 PM   #11
corn
Registered User
 
Join Date: Dec 2003
Location: here
Posts: 5,789
Re: Joined the club

A couple other things to check that might cause your problem... Im pretty sure the 4 door Blazers are like the extended cabs & require angled blocks to correct the pinion angle. Also make sure the drive shaft isnt pushed into the back of the trans. Lowering too far will do that & could cause some problems. I have a set of DJM 3" (V6) springs & a set of 3" angled Bell Tech blocks if you decide to keep it low...
corn is offline   Reply With Quote