[ericpost]

Originally Posted by skchevota

If you need to stack in the front, make sure it has the center pin going throug it( bolted through), and keep it at 1" or less. If you need more, use an add aleaf or modify your mounts/ shackles.
In the rear you should be fine with the 4" springs and the flip kit, that is going to give you about 8" of lift

The 4" shackle flip nets only 2" if you use the brackets on the opposite side to run longer springs (thanks to Grendel for that info).

I was thinking of stacking square stock to fab the bump stop extension