The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Longhorn Man · 02-28-2009, 01:15 AM

the draw on an LED should me so minimal that you could have 100 leds on that circuit and not have any problems.
Are you sure the switch isn't messed up?
I think you are just over thinking this.
Just run 12 volts to the switch, then out to the lights with grounds on each light. On the switch, a ground should be added to the 3rd terminal to light up the led.

02-28-2009, 01:15 AM	#3
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,690	Re: Switch question. the draw on an LED should me so minimal that you could have 100 leds on that circuit and not have any problems. Are you sure the switch isn't messed up? I think you are just over thinking this. Just run 12 volts to the switch, then out to the lights with grounds on each light. On the switch, a ground should be added to the 3rd terminal to light up the led.