|
Re: electric water pump heater hose routing Q?
Quote:
Originally Posted by Senator350
Well... Umm.... Kinda....
I'll have to search my puter. My camera phone just makes noise when I want to use the camera function...
So... as far as the late 80's water neck... The upper rad port is angled lower than on a traditional water neck. Thus focing me to relocate the water temp sender on my Edel Performer mani.
I haven't started working on the truck again yet (it's 20* out right now), BUT I'm considering using a water neck spacer (1" aluminum from Jegs or Summit).
Initially, I just ran an inline temp sensor housing in my upper rad hose, but then I couldn't find a 1/2"npt or 3/8"npt temp sender with the right ohms and sweep 
So, I've got this kinda bling aluminum inline port now, which I'm considering using for a Flex-A-Lite temp sender to control heated seat switches... or... hmmmm |
Sooooo, have you started the engine up with this setup, lmk if you get heat when you do. My idea is not panning out like I hoped, I may go your way and drill and tap the inlet if there is enough metal there to support it
__________________
Semper Fi...Uncle Sam, you da man
All parts offered to help are free, unless otherwise noted
Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST
AS usual, off topic
They say your mind goes second, can't remember the first
Jim
|