The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Tx Firefighter · 03-25-2009, 01:54 PM

There's plenty of meat there for countersinking. I drill the holes to 1/4 inch and countersink them to allow a countersunk phillips bolt to set flush with the surface. Then, apply the new sticker and it looks as good as new and will last much longer than original ever would.

Here is the kit that everyone uses. It comes with new face decals and levers and knobs.

http://www.oldairproducts.com/catalo...oducts_id=3776

03-25-2009, 01:54 PM	#14
Tx Firefighter Watch out for your cornhole ! Join Date: Jun 2003 Location: Azle, Texas Posts: 14,162	Re: Heater control question There's plenty of meat there for countersinking. I drill the holes to 1/4 inch and countersink them to allow a countersunk phillips bolt to set flush with the surface. Then, apply the new sticker and it looks as good as new and will last much longer than original ever would. Here is the kit that everyone uses. It comes with new face decals and levers and knobs. http://www.oldairproducts.com/catalo...oducts_id=3776 __________________ I'm on the Instagram- @Gearhead_Kevin Last edited by Tx Firefighter; 03-25-2009 at 01:58 PM.