Quote:
Originally Posted by jaros44sr
Sooooo, have you started the engine up with this setup, lmk if you get heat when you do. My idea is not panning out like I hoped, I may go your way and drill and tap the inlet if there is enough metal there to support it
|
I did not have my water plumbed when I ran my engine to test my ignition.
I have not had my engine running since then either...
BUT, I did run the electric water pump and my electric heater with the key in the accessory position. It circulated well, and I could hear most of the bubbles flushing out.
Whether or not it will all explode when there is water pressure and circulation through the block remains to be seen
