Quote:
Originally Posted by menace121978
thanks lolife99. i ordered djm spindles and the wheels i had on before. i would test fit them but i still have to order new rotors and calipers.
would the drop spindles make the control arm hit even though i ran the same wheels before? i'll probably end up doing as you suggested and touch them up when i install the wheels. and i'm not sure on the backspacing... do i just measure the lip on the inside of the wheel?
|
Yes. These drop spindles move the spindle itself up 3" in relationship to the ball joints. That makes the inside edge of the wheel closer to the lower ball joint.
Check backspacing by measuring from the center of the back side of the wheel,... up to the lip on the back side of the wheel. A 4" backspace will require a little grinding. 3.5" BS should clear fine.