The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

69ShortStep · 07-27-2009, 07:53 AM

Well, I found a very loose bolt on the drivers side bellhousing/trans mount. I tightened it up and the problem is slightly better.

Rotated the rear u-joint 180 which did not seem to make a difference.

While driving it to work this morning, the problem seems better in the cab but the same towards the rear.

I plan to inspect the adjustable panhard bar and maybe try the hose clamp to balance out the driveshaft.

TX FIREFIGHTER - do you have any other instructions/details on the hose clamp fix?

07-27-2009, 07:53 AM	#19
69ShortStep Registered User Join Date: Jan 2004 Location: Canal Winchester, OH Posts: 143	Re: I6 3spd Transmission Mount Well, I found a very loose bolt on the drivers side bellhousing/trans mount. I tightened it up and the problem is slightly better. Rotated the rear u-joint 180 which did not seem to make a difference. While driving it to work this morning, the problem seems better in the cab but the same towards the rear. I plan to inspect the adjustable panhard bar and maybe try the hose clamp to balance out the driveshaft. TX FIREFIGHTER - do you have any other instructions/details on the hose clamp fix? Last edited by 69ShortStep; 07-27-2009 at 07:54 AM.