|
Re: Eaton Rear axle pinion seal.
got up the nerve today. Borrowed the 1 5/8 socket and heavy ratchet and breaker bar and a homemade yoke wrench to hold it while i stood on a 6 foot cheater and jumped up and down to free nut. Then the yoke came out very tight on the splines ( a good thing) and I pulled all of the bolts holding the ring on the front. I left it on and stuffed a rag in where the yoke was to kep stuff out of the inside and looked over the seal ride. Not too bad but needs a little work polishing up. \
Is it possible to reposition the seal to run on a different area?? sure would be nice.
__________________
69 K-20 cloned to a 67 with front clip and some other stuff.
383 .040 over
Crane roller cam lifters and rockers ,1.6 intake ratio, Open chamber heads, 9.5-1 compression ratio, 2.02 intake valves , Edelbrock performer Air Gap manifold Carter AFB performer 750cfm, MSD ignition, SM465 NP205 4.10 gears: 
|