|
Re: Eaton Rear axle pinion seal.
HELP!!!!
The pinion bearings are pretty darn warm and feels like a brake dragging ..............
I am desperately looking for a diagram of the rear assembly to figure out if i have the bearing preload too tight by changing gasket on the retainer behind the yoke. I cleaned it good and cut a new gasket. The new material is like .015 thick and the old about .032/ Is the end play being affected on the pinion bearings????
I can't find a book here they are all in storage preparing to move.
I am bummed.
__________________
69 K-20 cloned to a 67 with front clip and some other stuff.
383 .040 over
Crane roller cam lifters and rockers ,1.6 intake ratio, Open chamber heads, 9.5-1 compression ratio, 2.02 intake valves , Edelbrock performer Air Gap manifold Carter AFB performer 750cfm, MSD ignition, SM465 NP205 4.10 gears: 
|