|
Re: Eaton Rear axle pinion seal.
I found a HO52 diagram online and it appears that the bearing load is set by a spacer in front of the front timken cone that is pushed by the yoke when it is installed. I am assuming now that the preload is not affected by the retainer cap at all. Maybe what I feel is okay for temp?? I can put my hand on it,,,,,,,,,,,,but it feels pretty warm after 25 miles. Any experts on this???
__________________
69 K-20 cloned to a 67 with front clip and some other stuff.
383 .040 over
Crane roller cam lifters and rockers ,1.6 intake ratio, Open chamber heads, 9.5-1 compression ratio, 2.02 intake valves , Edelbrock performer Air Gap manifold Carter AFB performer 750cfm, MSD ignition, SM465 NP205 4.10 gears: 
|