The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

JimKshortstep4x4 · 01-08-2010, 06:29 AM

A lot depends on the size of your compressor. My compressor puts out 13 cfm at 150 psi and it is not large enough to sandblast wheel size parts in a timely manner. (It works on small parts). If you don't have a pressure at a sustained cfm then it takes forever to sand blast a part.

Jim

01-08-2010, 06:29 AM	#3
JimKshortstep4x4 Senior Member Join Date: Jul 2001 Location: Muskegon,MI,USA Posts: 6,026	Re: rally wheel sandblasting A lot depends on the size of your compressor. My compressor puts out 13 cfm at 150 psi and it is not large enough to sandblast wheel size parts in a timely manner. (It works on small parts). If you don't have a pressure at a sustained cfm then it takes forever to sand blast a part. Jim __________________ 1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC