|
Re: Noises coming from throwout bearing..
Yes - I think kwmech is correct - the pilot bushing should press into the flywheel. Once had an odd situation where a PO had installed an auto trans flywheel on a three speed manual Dodge of some sort. When I re-did the clutch, the bushing supplied for the 4sp trans would not go into the flywheel. Bought a bushing for an auto trans and it pressed in correctly - fortunately the bushing ID was the same for both trans shafts.
These things do get mixed up, even by the manufacturer. If the pilot bushing is at all sloppy in the flywheel, could be the problem.
__________________
CCCC
67 Sting Ray Coupe 327 4sp; 68 K10 Suburban 327 4sp; 69 K20 Lifted 383 4sp; 69 C80 Fire Truck 478 V6 5sp/2sp; 69 C20 Longhorn 327 4sp; 70 C30 Wrecker 350 4sp; 70 C30 Flat Bed 350 4sp; 71 C20 LWB 350 4sp; 72 K5 Blazer 350 4sp; 72 C30 Flat Bed Gooseneck Hauler with sleeper 350/TH400; 72 C20 Longhorn 402 4sp; 52 Mack LTL Supercharged Cummins 5sp x 3sp; 01 Dodge 5.9 HO Cummins 6spd; 02 Safari Trek 2430 8.1 Vortec on Workhorse Chassis; 03 Silverado 2500 HD 4wd Duramax/Allison
Moved but still in the family
70 C20 Custom Camper 350/TH350; 72 K5 Blazer CST Highlander 350/TH350
Recently sent to new homes
72 C30 MoHome 402 4sp; 72 K5 Blazer Conv 350 4sp; 75 GMC 6000 Aerial 350 w Allison; 72 GMC 3500 Utility 350 4sp; 70 GMC 3500, 350 4sp
|