The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**LockDoc** · 03-10-2010, 11:15 AM

-
I would replace the wiper motor. It sounds like you have an internal short. It's not a fun job but it's not the worst thing I have done. The bolts are 5/16" if I remember right and there are two multi wire electrical plugs and one single wire plug. The clip on the wiper arms under the cowl vent and the arms can be removed and replaced without removing the cowl vent by using a screw driver or similar tool and a magnet. Hold the magnet on the clip as you remove it so it doesn't go flying. If your paint is good put some masking tape on the vent bars before you start.

Oh, and welcome to the board.

LockDoc

03-10-2010, 11:15 AM	#2
LockDoc The Older Generation Join Date: Aug 2006 Location: Montezuma, Iowa Posts: 26,069	Re: wiper problems - I would replace the wiper motor. It sounds like you have an internal short. It's not a fun job but it's not the worst thing I have done. The bolts are 5/16" if I remember right and there are two multi wire electrical plugs and one single wire plug. The clip on the wiper arms under the cowl vent and the arms can be removed and replaced without removing the cowl vent by using a screw driver or similar tool and a magnet. Hold the magnet on the clip as you remove it so it doesn't go flying. If your paint is good put some masking tape on the vent bars before you start. Oh, and welcome to the board. LockDoc __________________ Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 - Last edited by LockDoc; 03-10-2010 at 11:15 AM.