The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

threeonthetree · 03-28-2010, 08:13 PM

i edited my post above yours haha

i got a bad ankle right now its in a cast...

well check out my build thread at the bottom of this page is where i chopped the springs
http://67-72chevytrucks.com/vboard/s...=355750&page=2

just cut one coil off to achieve the drop. its a cheap starter i guess. there are lots of threads on it.
and the install on taht rear drop is also in my build threadd

no welding required at all. u do need to grind out 4 rivets tho.

03-28-2010, 08:13 PM	#12
threeonthetree Registered User Join Date: Feb 2009 Location: Wausau, WI Posts: 975	Re: Finally got some wheels! i edited my post above yours haha i got a bad ankle right now its in a cast... well check out my build thread at the bottom of this page is where i chopped the springs http://67-72chevytrucks.com/vboard/s...=355750&page=2 just cut one coil off to achieve the drop. its a cheap starter i guess. there are lots of threads on it. and the install on taht rear drop is also in my build threadd no welding required at all. u do need to grind out 4 rivets tho. __________________ Smoking Tires Since 1992 1969 c10 AKA SIN 1985 SSWB TRAZER (super short wheel base) Last edited by threeonthetree; 03-28-2010 at 08:14 PM.