The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

67mbsc · 04-25-2010, 05:05 PM

I have a 1968 C-10 with a manual trans, and a small block engine. The starter has a cast iron nose, and the mounting bolts go thru the nose, into the bellhousing, and NOT the block.
My question is, where can I find the correct bolts, as each of them is different. The bottom one will have a large shoulder, the middle one has a smaller shoulder, and the top, that bolts thru the bellhousing, into the starter, may not have any shoulder!
I have NO bolts right now, had my local dealer look, they even called the factory, and nothing came out!

I want to keep the starter that I have it's new, and I don't have any block mount starters right now!
The hole for the bottom bolt is almost 7/16". Is there a bushing for this?
Thanks,

04-25-2010, 05:05 PM	#1
67mbsc Senior Member Join Date: Jan 2005 Location: Myrtle Beach, South Carolina Posts: 266	Which Starter Bolts Do I Need? I have a 1968 C-10 with a manual trans, and a small block engine. The starter has a cast iron nose, and the mounting bolts go thru the nose, into the bellhousing, and NOT the block. My question is, where can I find the correct bolts, as each of them is different. The bottom one will have a large shoulder, the middle one has a smaller shoulder, and the top, that bolts thru the bellhousing, into the starter, may not have any shoulder! I have NO bolts right now, had my local dealer look, they even called the factory, and nothing came out! I want to keep the starter that I have it's new, and I don't have any block mount starters right now! The hole for the bottom bolt is almost 7/16". Is there a bushing for this? Thanks, __________________ 2% Forever!!!!!!