The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Will C-20 body parts work on a C-10?

Shyguy · 09-03-2010, 08:03 AM

I bought a '67 C-20 lwb stepper along with a '69 swb frame from one of my grandsons. We swapped all the sheet metal over to the swb frame without a problem, well there was one.

We used the 3/4 ton cab mount bushings on the swb frame. We could not get the right gap/alignment between the front clip and cab. After a little research we found out that the rear cab mount bushings on a 3/4 are thicker than 1/2 ton.

09-03-2010, 08:03 AM	#6
Shyguy Junior Member Join Date: Dec 2006 Location: Southeast Missouri Posts: 2,436	Re: Will C-20 body parts work on a C-10? I bought a '67 C-20 lwb stepper along with a '69 swb frame from one of my grandsons. We swapped all the sheet metal over to the swb frame without a problem, well there was one. We used the 3/4 ton cab mount bushings on the swb frame. We could not get the right gap/alignment between the front clip and cab. After a little research we found out that the rear cab mount bushings on a 3/4 are thicker than 1/2 ton. __________________ '67 Chevy C-20 short stepper - build complete, 454/SM-465. '75 C-30 Single Cab DRW-350 small block/NP-435. '77 GMC-6500 Dump Truck, 427 Tall Deck. '92 GMC K-3500 Duallie, 454/4L80E.